Welcome to Ver

unofficial service & repair forum

We repair a wide range of Ver Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

🛠️ Common AI Repair Summaries 🏭

Comments for Ver

📝 John Williamsen said:

We have received a photo of what we believe to be a VERSATYME electo/mechanical controller. It is on an LA Water brand water treatment unit. Question is, if we send the photo to you could you identity the brand as a VERSATYME? Please e-mail back.John

➡️ Reply Versatyme Controls

📝 Jose Luis Bravo said:

Please be so kind to quote: Two pieces of part number AX915034P Board Driver for Versaply Label MachineThanks so much

➡️ Reply Versapply

📝 Don said:

HI, I have a versapply 9100R-40 that has been in storgae for a while. We would like to attempt to use it but we have no operators manual , schematic diagrams or anything to work with. Do you have any liturature to help. We are willing to pay for it. We also have a 77 Doboy supermustang wrapper we are looking for information on. Thank you for your time and God Bless America, Done-mail-- DonandVon@comcast.net

➡️ Reply Versapply

📝 Don Page said:

HI, I have a Versapply labeler and its in good shape and it was working ok but someone screwed with the controls on the circuit board ( AX915033P ) and I cant seem to get it synced with the prduct on the conveyer. It sometimes spits out three labels instead of one. We are atempting to use it on a single wrapped cookie 4 by 4 and 1/2 inch thick . Would you have any drawings or instruction on what pots does what to the delay etc. There are several on the board. I also have adjustments on the product sensor Sunx CX- PRVM3. Any help would be greatly appreciated. Are there any download sites for instructions on setup you know of for this vintage of Varsapply? Thanks and God Bless America, Don

➡️ Reply Versapply

📝 Craig James Titzkowski said:

I need to know how to get replace ment parts and a manual that shows the parts so I can order the part I need that would be of great help. I work maintenance for Trident Seafoods and am just doing some tracking down of info for my Chief. So we can order parts we need

➡️ Reply Versapply

📝 hamad al sanad said:

Hi There...Iwould like to have the specification for:1-Air speed Sensor (model 7100_ a part number 07212-2A)2- Altitude sensor(model 7000 _ a part number 52772 )3- air temperature sensor (platinum resistance thrmometer _a part number s9690pl1z12)

➡️ Reply Vernitech