Welcome to Unimac

unofficial service & repair forum

We repair a wide range of Unimac Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Unimac unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Unimac

4 comments found.

bharat patel: i have a uni mac washer need to repair,not dran porporly
Reply

  

Nizuyir: I removed my unimac washer drum for replacement of the bearings in the trunnion.There are two V-rings installed. The outside diameter (OD) is 8.5 inches, and the inside diameter (ID) is 5 inches and thickness is 0.5 inch. I am unable to get the part numbers or suppliers for these items.Could anyone help to identify the parts and also where I can get them.Thank you.Nizuyir Buyong.
Reply

  

BEVERLY Maxwell Newirth: I NEED KEY FOR UNIMAC WASHER KEY #3800
Reply

  

Eddie Thomas: Where is the nearest service shop located. Need to know the cost for maintenance and repair.
Reply

  

George Park: 50lb unimac invatar control system.
Reply

Viktor: Gents, I need P N for belt for UNIMAC Dryer UB075 E (big one)Thanks
Reply

  

Ramesh Ragha: I 'm looking for a wash motor for UW60P30, slightly used or new, please e-mail me on a price. Thank you.
Reply

    

charles onstead: looking for a elect motor for unimac um50p3 washer, unimac p n 1039266480. voltage 208-240 hz60 wire 4 amps 13 5.5 hp .65kw 530 rpm motor model cp132 c 8-12-2t-4411.please advise price and deliverythanks
Reply

JAY PATEL: WE NEED A REASONABLY PRICED GOOD USED OR NEW CYLINDER AND TRUNNION ASSEMBLY FOR UNIMAC DRYER MODEL # DTB75CGK ALSO CAN USE INNER AND OUTER TRUNNION BEARINGS FOR SAME MECHINE.
Reply

bipin v patel: WASHER IS NOTY WORKING,FUSE F21 WAS BAD,WHEN WE CHANGE THE FUSE ITS BLOW OUT AGAIN,DURING THE WASH CYCLE.
Reply

---