Welcome to Sanyo Denki

unofficial service & repair forum

We repair a wide range of Sanyo Denki Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Sanyo Denki unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Sanyo Denki

4 comments found.

santosh kumar chauhan: Dear sir I am using PM driver (sanyo denki PMM-MD-23120-10) for stepper motor (sanyo denki 103H71121-0410). As I selected pulse direction mode the motor runs in CW direction only when I down the direction pin low. The output of PC4 is high when its input is low. what is wrong with PM driver ?rgdsSantosh K. ChauahnRRCAT Indore(INDIA)-452013
Reply

  

sreekanth reddy: Sir,i am using sanmotion TS1-AA2AA for sanmotion servo motor.this a fully programmable drive.the main problem i am facing with this one is iam enabling the servo on function any time.but the servois not switched means 140v to the drive is not going.please tell me the solution,regardsSreekanth reddy.C
Reply

    

sankar: sir,our cnc m c brother tcs2a table axis servomotor (sanyo denki) having position shifting error is facing because of encode got detororated due to coolant entry. is it possibe to change the encoder , if it is possible please guide me.thanks®ardss.sankar
Reply

  

Nir Ben-Hur: Hi,I have few (around 5) PM Driver (Model: PMAPA1A6B20) units that failed while used at TEL Prober Machine. The part age is 3-4 years.Usually the problem reflects as noisy motor and motion followed by encoder errors. What will the common repair cost for that?Best regardsNir Ben-hur972-54-3339535
Reply

Arpit Bhatnagar: We have one equipment in which sanmotion motor is used for motion and now gone bad. we want to repair this motor. Symptoms:- Armature jam, Tight in motion.Model no:- Q1AA06040DXS24MMake:-Sanyo Denki.Please reply soon.
Reply

  

SRIKANTH R: we have amplifier sanyo denki make1.60BA100FFW0H2.60BA030FXW0T3.60BA030FXW0PPLEASE HELP US IN GETTING CONNECTING MANUALSREPLY SOON
Reply

---