Welcome to Powcon

unofficial service & repair forum

We repair a wide range of Powcon Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

40+ years of experience repairing Industrial & Commercial units
Certified Senior Industrial Electronics Technician
Ability to do Reverse Engineering
No job to big or small
Fast turn around time on most units
Quality of work comes before profit!
Old Fashion Customer Service is always the right policy
Extended warranty
Fair Estimates
Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Powcon unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Comments for Powcon

3 comments found.

Bryan Perry: I have a Powcon 200sm with wire feeder. The drive board went bad in the wire feeder, so I replaced it. Now I do not have fire on the mig gun the inch and purge switch do work and when you pull the trigger it does feed wire and the gas solenoid also accuates. There is 28 volts at the connector in the back of the power supply I believe on pins 1 and 2. I tried to jumper pins 3 and 4 but could not hear the contactor. Upon opening the power supply and visually looking at the PCB board it appears to have been hot. Would you please email the procedure for troubleshooting the contactor set through the pin connector on the power supply. Thank You
Reply

Ray Clauss: is ther a parts list for a powcon board #107029 ? I need to replace CE2.
Reply

jack dowling: i would like a manuel
Reply

Marino Octaviano Velastegui Gavilanes: Nosotros queremos reparar una máquina soldadora POWCON 200 SM.Necesitamos los siguientes repuestos.Cant # de denominación01 PC BOARD ASSY 105019 REV01 BUS 300v GMQ 3.21004 U.K. 919000-3 900202 900000-001ADEMÁS NECESITAMOS UN DIAGRAMA DE CIRCUITOS ELECTRICOS, que tenemos dificultades con su instalacíon.fUENTE DE PODER SERIE # 2M102302
Reply

Tim Murphy: Have not used welder in 30 years worked great thenI tried to use it and it would not weldthe wire feed works okthe only think different I do not have I dont have the co2bottle attached question is there a switch connected to the co2 that is keeping it from weldingCould use a little hekpThanksTIM
Reply

dan: Looking for a powcon 200 sm manual please!Thank you,Dan
Reply

prosper Amedume: Unit in need of repair Powcon BD103025 industrial unit with a circuit board issue. Its not powering on despite all connections being secure. Looking for expert assistance ASAP.
Reply

ron: hello am converting welder from 460 to 230. i located the 3 buss bars. and changed them. i turned on power and power indicator light an fan comes on. but no power to weld with , any info would be great . thanks
Reply

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z