Welcome to Nuarc

unofficial service & repair forum

We repair a wide range of Nuarc Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Nuarc unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Nuarc

2 comments found.

Rick Gustafson: Nuarc Model # SST1418TR Serial # 94B68-38Looking for the solenoid to operate the camera shutter. Wondering if you sell this part?
Reply

Edward Rivera: I don 't have a manual for it and i have rapid acess film for it. I also don 't know where to set the lens for line and haft tone. Pleas help me out. Thank You.
Reply

  

dennis: I am using a nuarc vv1418 camera with rapid access film, I always get a weak or dark image out in the corners. Longer times weaken the center of the image. wondering if the angle of the lights is wrong?
Reply

  

XAVIER GALLARDO: Hello: looking for a NuArc VV 1418 Itek LensThanks
Reply

  

Anthony Mitchell: When I turn the camera on it comes on for just a second then turns off. It does not trip the breaker just turns itself off. I do not know where to start. Electricial, swtich or board problem. I teach at a Career Technical School and do not have much money to fix equipment so I need to fix it myself. Thanks for any suggestions.
Reply

  

Anthony Mitchell: I have a NuArc process camera, it is old but does a good job. When the power switch is turned on the camera comes on but after about 10 seconds turns off. I do not know where to start. What is your best guess of the problem and the estmated cost to fix it. I teach printing to high school kids so money is in short supply. Thanks for any help. The camera is a NuArc vv 1418
Reply

  

Jeffrey: lowered the bed to reduce and bed will not come back up any suggestionsThank youJeff
Reply

Aaron Bass or Eric Gant: We are a small art school with a broken NuArc unit (specs below). It seems to be a loose wire, as the bottom row of buttons (start, cancel E8, etc.) will not start. So, we are looking for a repair person in the area.Unit specs26-IKS-NTNT C00-005120609.5ThanksAaron Bass
Reply

---