We repair a wide range of Larko Electronic Equipment.
Ask questions, or call 1-336-969-0110 for faster service.
Use the search bar above to find specific manufacturers.
Michael Bellesfield: Hello...Just a quick question. Do you have a schematic or parts list for the Larko commercial vehicular gate operator Model MKI #41 ??Need to identify the value of what looks like a high voltage capacitor in the motor driver circuit. No values are printed on the part itself. The part is bright red with about one half inch diameter. Seems to form a filter (along with a high current) coil between a 15 amp fuse and the motor itself.If you have either the manufacturers diagrams or the capacitor for this unit would you please contact me as soon as possible?Thank you,M. Bellesfield323-960-4315net_workz@hotmail.com
Reply
Eugene E. Kercher: My community has a Larko Commercal Gate for the community. Where do you suggest I get a car remote for it?
Reply
Marty Mangum: I need the nylon wheels stops that turn off the opener for a Larko Model MKI-41. Where can I get them?
Reply
Raul Martinez: Hello:Could you please share the board to Motor connections diagram for the LARKO MKI-40 gate opener?.Ill appreciate your helpBest regards.
Reply
Curtis Belk: My opener has been unused for the last 5 years and now i would like to get operating again. All the parts are there and the logic board has been upgraded. Need to know how to jumper it to so that i can operate it and reset the open and closed stops.Thanks in advance Curtis Belk
Reply
John: I have a Larko 80-60E swing gate controller that is no longer working. The Logic board is a 24-02 Rev 15 and the Power board is a 24-04 Rev 3. Do you have replacement boards or schematics / manuals?
Reply
Fred Mastriona: Looking for the repair manual for the above mentioned gate opener. If you have knowledge as to where one could get a hold of one of these, I would appreciate it.
Reply
Ernesto Chavez Rice: Where can I purchase a repair manual and schematic for a Larko MK I40 gate opener ?
Reply
PhilA: Replaced drive motor, but need information on how to retime the opening and closing.
Reply
DION LEWIS: I installed a new belt on the larko model I #41 an it will open just fine but will not shut. There is nothing blocking sensor nor there is no sound from motor at all if you can help i wouold suer appriciate it thanks dion
Reply
STEVE PATTON: I NEED TO AUTOMATE GATE (CLOSE AUTOMATICALLY). I NEED DIP SWITCH CONFIGURATION.PLEASESTEVE
Reply
Tate Hernandez: Where can I purchase a Larko gate opener?
Reply
calvin l.: Hi. My driveway slide gate motor belt broke,Larko electronic,Would you please tell me . Where can I get the belt around Los Angles area. Tkank you.
Reply
Julie Lee: Hi: We are looking for a parts list for a old type Larko slide gate operator if you are able to help us please e mail any for fax us @808-676-5800 and thanks for your help. Julie Lee at Servco Raynor OverHead Door Inc.Ph#808-676-3667 Pacfic time
Reply
Mark Whitton: I have a Larko Slide gate operator, I have no manuals or diagrams for this gate but am pretty sure that the control board needs replacing or repair. I was hoping to get a quote on repair costs. I dont know the model number on the board. My cell number is 843-343-8552. Thanks.
Reply
RUDY BARRIGA: I HAVE AN OLD (1990)LARKO GATE CONTROLLER MODLE #MKI #41AND I AM TRYING TO FIND OUT WHERE I CAN GET PARTS FOR THESE UNITS. ANY HELP WOULD BE APRECIATED.THANK YOURUDY.
Reply
Tom Ward: Were you happy with the help and any service you recived from Industrial Electronic Repair Tom
Reply
Dan: I have a Larko ASSY 30-45/46 cant read the modle# its a 1987 slide gate controller the boards have malfunctioned is there any service or replacement?
Reply
behzad: dear siri am behzadi live in iran i wanet to buy electronic parts for sell in the iranplease help me to buy this partsthanks
Reply
julian: larko mark V logic board
Reply
Everett R. Lucas: How can I get a wiring schematic for a Larko commercial gate opener model MK T #40, ser. # 54431, built in Nov. 1990? Is there a service manual available? I would appreciate any help I can get on this opener. Thanks.
Reply
Dan Michelotti : I need a estimate on a gate repair , The unit has no power past the low voltage transformer I think its suspect and could be out because none of the operation lights come on and I get 120V going in to it but noting comming out ......Make : Allister -larcoModel:Mark I-40Build year 1993 115 V @ 4.5 A If you could call me with some info I could used that would be cool....Dan Michelotti916-613-8777Michelotti-Engineering Lic# 830295
Reply
paul schlegel: purchased in 1995
Reply
Lynda: Need to replace sprockets on my Larko Mark I Gate Operator.Do you have any parts that work for that model.Or any suggestions.
Reply
Lynda: Need to replace sprockets on my Larko Mark I Gate Operator.Do you have any parts that work for that model.Or any suggestions.
Reply
Linda Ciarimboli: Hi. I purchased a home with a 1991 Larko MKI40 gate opener installed. It stopped opening today. Is there somewhere I can get manuals for it? Are parts still available?Do you recommend a certain repair company?Thank youLinda C
Reply
John Anderson: Do you sell power boards for the MK 140 opener or just repair them. If so how long does it take and how much does it cost. Thank You....
Reply
ken: Im experiencing issues with my Larko Electronic 24-02 board. The unit is not powering on at all, and there seems to be no display or response when attempting to use it. Considering the complexity and value of the unit, may I please know the estimated cost for replacement if repairing it is not feasible? Thank you.
Reply