Welcome to Inventron

unofficial service & repair forum

We repair a wide range of Inventron Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Inventron unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Inventron

2 comments found.

Donald Clemons: I have a Uni-Sonic Instruments System, Model EC 200-1 and T200-1-1-EP-N Serial No. 1841 (Date in service June 15, 1977). Broadcast frequency is 218 kHz. The vendor manual I have for this hardware is dated 1973.This application measures level of product and the voltage is inverted with zero reference point 14 ft from the mounting flange. The output signal is 0-5 VDC over 0-14 ft. My Operators report that the level alarms for this unit are actuating early, causing level of product in the vessel to be less than expected. I 've found very little other information onsite about operation of this equipment. Are you familar with this admittedly antiquated hardware, and if so, is it parts supported? Finally, Please advise
Reply

  

arthur merkl: all equipment ever manufactured by Inventron can be repaired at the factory.734-513-7700Arthur W. Merkl,General Manager
Reply

---