Welcome to Industrial Electronics Repair

We repair a wide range of Industrial Electronics Repair Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Industrial Electronics Repair unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Industrial Electronics Repair

3 comments found.

Sales Service: If you need your unit tested or repaired then give us a call.We offer fair estimates and offer extended warranties.You can contact us at 1-(336)-969-0110Shipping ReceivingIndustrial Electronic Repair931-E S. Main St #204,Kernersville, NC 27284 Phone: (336) 969-0110We repair industrial electronic devicesIf you have an industrial electronic device that needs repair,Feel free to contact us!
Reply

  

Francisco: I have 2 Goring-Kerr (Thermo Fischer Scientific) DSP2 metal detectors that show the following faults in the status page: Faults: 3 Product memory - search head - RF board. I do not have the operator supervisor Engineer passwords and the password seed numbers are (what I assume is by default): Operator: 12345678 Supervisor:23456781 Engineer: 34567812. I have tried using password ZBZB but it does not work. Conveyor belt turns on and off and red fault light is on. Any suggestions? Thanks in advance.
Reply

---