Welcome to Inductotherm

unofficial service & repair forum

We repair a wide range of Inductotherm Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Inductotherm unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Inductotherm

2 comments found.

Scot: Inductotherm 804237 circuit board experiencing intermittent power loss, causing disruptions in industrial unit operation. Need immediate assistance for repair.
Reply

Scott Tewell: I have a z board that needs repaired. This has a micro-controller on it. Have you done these in the past?
Reply

  

Devin Villacruz: Hi, I would like to ask if the Z board can be calibrated? Reasons: 1. Out of tune. 2. Cannot attain full power. 3. Cannot attain 1200hz frequency. 3. ACR over-voltage tripped.Current condition: 1. Power can reach up tp 400kw only. 2. Frequency up to 1000hz only. 3. Turn on time too long (10secs). 4. Initial voltage upon inverter on is 500V (too high).Induction furnace model: VIP powertrak 500 R series.Company: Negros Metal Corp. Murcia road, Alijis, Bacolod City Negros Occidental 6100 Philippines
Reply

---