Welcome to Holzma

unofficial service & repair forum

We repair a wide range of Holzma Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Holzma unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Holzma

2 comments found.

william rberson : where can I get technical help and manuals for this saw
Reply

Rolando Rivera: Machine not finishing "initialization ".It has the old small screen "operator panel " BRRTGR31-OF.Sequence of events:1- machine main breaker is turned to ON.2- +- fourteen seconds later, there is a glitch to the LEDs switches.3- the "HOLZMA " logo is displayed on the small screen.4- operator stays waiting for the 2nd glitch on the LEDs and the black boxes on the screen indicating the initialization is finished. Number 4 above never happen.There are no errors on the panel. Removed all boards but PLC and Screen I F MC02 = same result. Any suggestions?
Reply

  

Ramunas: Replace green battery in comunication board.
Reply

  

Douglas Gessford: We have a 1998 Holzma HPP 1132 panel saw. We have been told that the positioning module is bad(CPNC8-23). We replace the drive motor and still intermittency.Cannot find a positioning module anywhere. CAn you repair this or locate aa positioning module for this saw? Please call me at 859-497-0058 EXT: 214Doug GessfordorDaryl EasonorDusty
Reply

Randy Peek Markus Cabinets: We have a Holzma hpp350 panel saw and we believe the cylinder that raises the main saw is going bad. We are wondering if these cylinders can be rebuilt or if they need to be replaced, please advise and thank you
Reply

---