Welcome to Hofliger & Karg

unofficial service & repair forum

We repair a wide range of Hofliger & Karg Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.


Why to send us your work?

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

Comments for Hofliger & Karg

3 comments found.
Sheldon Clark: we have a gkf-50 encapsulator we were looking for a manual or photographs of this machine for our reference
Reply
  
Bogie Destya Manendra: Dear,We have Filling machine (Dos micro), Type : ZB-50. We need spare part for shaft machines, such as auger shaft, gear shaft and base plate shaft. Can we get any information related with the spare parts ?Regards,Bogie Destya ManendraEngineering Section HeadPT. MEIJI INDONESIAPhone : +62-343-741102Fax : +62-343-741103Email : bogie@fact.meiji.co.id
Reply
Zoran Golubovski: Dear sir/madam, We have a weight control unit, included in an automatic packing line for packing solid (powder and granule) products in a bags. At the weight control unit there is a plate with the folowing writing: H + KHOFLINGER + KARGWaiblingen bei Stutgard Germanytype: KWE 200Vmassh. No.: 4W1.2665.01.70This weight control unit we have conected with a packing machine (OPTIMA) and it controls the weight of each bag that is packed. At the same time if the bag have biger or lower weight than needed it is removed from the line, and the unit sends a signal to the packing machine to correct the filling. We bought this weight control unit as a second hand equipment (back in 2001), and we have no documentation for it. At the begining it was very dificult but now I can say that we know enough about this equipment. But still for my safety side manipulation with this equipment I need some documentation. So my questions are: - do you have any documentation for this equipment as: electrical cheme; electronical cheme; user manual; maintainance manual etc. - this model is very old, can you sugest any newer model which can replace ours. thanks in advance regars Zoran Golubovski
Reply
  
JUAN MANUEL ALEMAN: I have a machine weigher in our plant, bat ther are not have the electrict circuit information and operation manual, I need your help with this information. Can you send my this information?This machine has the following data.ROBERT BOSCH GMBH TYP:SWDKS, NR:W1.5002.01.74HOFLINGER + KARG.Thanks...
Reply
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z