Welcome to Greenlee Tool

unofficial service & repair forum

We repair a wide range of Greenlee Tool Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Greenlee Tool unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Greenlee Tool

3 comments found.

mike howard: I AM LOOKING FOR A SPECIAL CAPICATOR FOR MY 555 BENDER . ON THE CONTROL BOX COVER IT HAS A CONTROL # 501-8897.6 I KNOW IT IS AN OLD MACHINE BUT IT WORKS VERY GOOD AND I DO NOT KNOW WHERE TO FIND THIS CAPICATOR. ANY HELP WOULD BE APPRICATED. THANKS MIKE HOWARD
Reply

  

David Friedhoff: We have a greenlee 555 bender the chain has broken where can I find this part
Reply

Allan Morris: We are in need of a repair to our Greenlee 855 Electric Bender, serial number: ADY4773B. This unit most likely has electronic issues due to a mouse building a nest internally. Currently the unit will not operate at all.Would the bender have to be shipped to your facility?Do you offer onsite repairs for our location?
Reply

  

JOE SHERMAN: brand new greenlee 855 gx bender. was adjusting the brightness of the lcd screen and the screen went super bright rally fast. now I can't see anything but a bright white screen.is there any kind of a reset or something I can do to reduce the brightness of the screen ? when I first turned the machine on there was lines beside all the buttons I could read and now I can't read them. any help would be great thank you
Reply

---