Welcome to Fieldpiece

unofficial service & repair forum

We repair a wide range of Fieldpiece Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Fieldpiece unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Fieldpiece

2 comments found.

David: My meter will not read amps, it read volts and every thing else but when it comes to amps the meter just scales from 0-300 over and over and when clamped around a wire it will still not read amps, is this worth repairing or can it be repaired any estimate of what it would cost?
Reply

  

fredie: my fieldpiece HS 35 blown when i tried to used it to read microwave voltage.i replaced the fuse but its still not working.i realised i have used it over the maximum rating which is 700 volt ac.but i assume the fieldpiece has some protection again it.
Reply

Benjamin F Graves: Hi i 've tried several times to cailbrate my Fieldpiece HS26. I can only get it to go down to 200V and thats as far as the pot screw goes. should I send it in to you? Or is there something else I can do. Thank you Ben F Graves. Senior Lab Tech-Earthsytems South West, Bermuda Dunes California92203 USA.Phone 760-345-1588 EX-3316
Reply

Ben F Graves: hi I sent my HS-26 to you fro Repair did you recive it . Please let me know Thanks Ben
Reply

---