Welcome to Eason

unofficial service & repair forum

We repair a wide range of Eason Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Eason unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Eason

1 comments found.

Foot Young: Hi, I 've got an Eason ES8 DRO that when booting up just displays all 8 's on the axis scales and just Chinese characters on the right hand readout. I suspect it is the CMOS battery, as it is 5 years old, hasn 't seen much use, but over the last month or more, sometimes it would only display as above, but if I kept turning it off and back on I could eventually get it to come good. Today however, now amount of coaxing would get it right. I tried it without the plugs in that go the the sensors, no difference. I took it apart and checked the battery voltage, it is a 2.4 80mAh battery, and it reads 2.39 volts. It is set to 110 volts and on checking that it is getting 122 volts from the transformer in the milling machine. I could send it to you, as I can 't find anyone here in OZ who repairs them, but the postage would cost half what a new unit cost. Can you provide any advice please. Thanks.Foot
Reply

---