Welcome to Scofima

unofficial service & repair forum

We repair a wide range of Scofima Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Scofima unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Scofima

4 comments found.

Howard Neal: Dear sirDo you recognise this board and do you have a schematic for it because some clown has cut all the wires and we need to reconnect it??Regards, Howard Neal, Burner Plus services, Cyprus.
Reply

  

Emil: I have 2 spotwelders with scofima sm219 a controlers.None of these welders whants to fire. The sequence is right but no welding ocurs. led 16 is also flashing ? Can u help me
Reply

    

Safco Systems s.r.l.: when led 16 is flashing means "current off " no weld, it is sufficent to push "+ " key to switch in current on
Reply

  

M.Kaviani nezhad: Hello dear chairmanwould you please introduce only the name of software for programing welding machine : IP3 S470 ?With best RegardsNovin Andisheh Kavian
Reply

  

David Jones: How can I get a drawing that will show me the proper wiring of this unit. I Have a control that will not light up. I have no way of knowing which terminal is the incoming 24vdc feed, so I can 't determine if the control is bad or just not getting power. I do have 24vdc on terminal # 14.Thank YouDavid JonesSoutheastern Sheet Metal1245 Ennis rd.Dothan Alabama334-793-3440
Reply

Jan Czarnota: Could I get the electrical diagram of board: SM48 ?This is Thyrystor control board.With kind regardsJan Czarnota
Reply

  

Safco Systems s.r.l.: Hello Sir. we are ex Scofima System we have all schematic pcb etc of Scofima System, if will be usefull to repair any unit or have it new don 't hesitate to contact us,Best Regards,Safco Systems s.r.l.
Reply

  

doquy: I have a circuit board of Scofima System SM48 but there is no function of the pins! Can you send me the connection method of the board?
Reply

---