Welcome to Bristol Saybrook

unofficial service & repair forum

We repair a wide range of Bristol Saybrook Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Bristol Saybrook unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Bristol Saybrook

2 comments found.

KEN CLARK: I have a customer looking for Bristol Saybrook control motor on milk system mod# 447881k-1 8m1 20 rpm 240volt 1 ph can you help
Reply

  

Leighton Wong: I have a Bristol Saybrook electric motor that is used for a case annealer for rifle cartridges. The model is 447, 511D-W, 81k, 4 RPM, 120 v, 60 Hz, 4 W. The motor works however when load is put onto the motor it stops rotating the cartridge holder. The spindle on the motor goes into a drive drum about 1.25 inches in diameter and an o-ring is on the drum which drives the cartridge holder by tension put on the two parts from a spring. I do not have the name of the case annealer. Can you tell me if you can repair the motor or if you have a replacement motor with the same specs especially the rpm and the mounting bolt location? Thank you very much.Leighton Wongemail zat.leighton@gmail.comphone (808)206-4653
Reply

---