Welcome to Bentron
unofficial service & repair forum
We repair a wide range of Bentron Equipment.
Ask questions, or call 1-336-969-0110 for faster service.
Use the search bar above to find specific manufacturers.
Why to send us your work?
- 40+ years of experience repairing Industrial & Commercial units
- Certified Senior Industrial Electronics Technician
- Ability to do Reverse Engineering
- No job to big or small
- Fast turn around time on most units
- Quality of work comes before profit!
- Old Fashion Customer Service is always the right policy
- Extended warranty
- Fair Estimates
- Low Prices
To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.
If you need your Bentron unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.
Comments for Bentron
1 comments found.
droulez: Good Morning,I have got a Power supply with those characteristics:Type: PEE 21 24 2.0Input: 220VAC 310VDCOutput: 24V 2ASeries #922Can you give me by e-mail the user 's manual of that power sypply (especially the rear panel with 15 PINS)RegardsING. F. Droulez
Reply
saeed: hi dear sir.i need to connect my old barudan to my PC.so i need this information about barudan com port.1- barudan com port (D-Connector 25 pin) pinout names.2- if this port is a serial port, with what boudrate i can send data to machin?i hope you help me.thank you.
Reply