Welcome to Ball Electronic

unofficial service & repair forum

We repair a wide range of Ball Electronic Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Ball Electronic unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Ball Electronic

75 comments found.

Naveen: i need circuit diagram & fault finding of philips 107 b7 17 " cdt colour monitor using STR G5643B in power supply ..
Reply

doug wagner: hi, i have a cnc monichrome monitor that the two TO-3 output regulator trans. on the upper left of the monitor brd shorted.they do not have a good part #can you id them?I have serviced television for 30 years and would like to save some money getting my own unit repaired.appreciate any info you can supplyDoug
Reply

P.K. Jain: Dear Sir,I have a 17" HCL Monitor No. HCM782M. The monitor is dead. It is suspected that STR of its power supply has been burnt.You are requested to kindly provide me the power supply's STR No. and circuit diagram of the Power Supply of HCL Monitor No. HCM782M, with the mentioning of voltage at its components.Thanking you.
Reply

---