Welcome to Autonumerics Inc
unofficial service & repair forum
We repair a wide range of Autonumerics Inc Equipment.
Ask questions, or call 1-336-969-0110 for faster service.
Use the search bar above to find specific manufacturers.
Why to send us your work?
- 40+ years of experience repairing Industrial & Commercial units
- Certified Senior Industrial Electronics Technician
- Ability to do Reverse Engineering
- No job to big or small
- Fast turn around time on most units
- Quality of work comes before profit!
- Old Fashion Customer Service is always the right policy
- Extended warranty
- Fair Estimates
- Low Prices
To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.
If you need your Autonumerics Inc unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.
Comments for Autonumerics Inc
2 comments found.
John Adelmann: I have been running a Shizouka 3 axis mill for a particular job for 15 years and have run into a X motor control problem. The X axis vibrates in place at any feed rate right now. I have swapped 2 stepper cards and both x and y motor drives in the mainpower box with no changes in result. The motor itself turnsrelatively freely without powered up. What would be my next step. I have I O boards from a 1970double spindle unit available but I hesitate to switch them out.John
Reply