Welcome to Applied

unofficial service & repair forum

We repair a wide range of Applied Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Applied unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Applied

1 comments found.

Maurice Bennink: Hi:I acquired an old 2-1 2 " Sterling extruder and would like to remove the screw. Could you tell me how the screw is held in place and or how to remove the screw?Thank you in advance,Maurice Bennink
Reply

John Elkins: I am emailing on behalf of the Agriculture Dept of Stephen F. Austin State University. We have a Torchmate CNC plasma cutter table and the motor driver blew out one of its axis 's. We are still functioning on the other 2 axis 's. Torchmate quoted me almost 700 dollars for a new driver and cables. Our department, like most state funded schools is very limited on what we have money in our budget for; and repairs to this machine after only being online for roughly a year are not part of that limited budget. How much for repairing the motor driver? What is the normal estimated turn around time for this sort of thing, it is right in the middle of a very important project.If I need to get numbers off of the box please let me know. You can call me between 10-8 M-F, calling is usually the fastest way to reach me. Thank you, John ElkinsPresident of Ag Engineering Technology Club.
Reply

---