Welcome to Accu-Rite

unofficial service & repair forum

We repair a wide range of Accu-Rite Equipment.

Ask questions, or call 1-336-969-0110 for faster service.

Use the search bar above to find specific manufacturers.

Why to send us your work?

• 40+ years of experience repairing Industrial & Commercial units
• Certified Senior Industrial Electronics Technician
• Ability to do Reverse Engineering
• No job to big or small
• Fast turn around time on most units
• Quality of work comes before profit!
• Old Fashion Customer Service is always the right policy
• Extended warranty
• Fair Estimates
• Low Prices

To receive more information about your unit then fill out the email form below
and we will be in contact with you within 24 hours.

If you need your Accu-Rite unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a exteneded warranty.

Your Topic

Your Name

Your Email

Your Location

What would you like to ask or report?

Submit Comment

Comments for Accu-Rite

4 comments found.

Bruce Thomas: I would like to know if you sell new or used accurite III dro 's?Mine is a lost cause. It was being used in the z axis and in congunction with Servo system 3 axis milling machine retro-fit, on a Lagun ftv-2 base machine. the 2 other axis dro 's are fine.. Bruce
Reply

  

peter: where can i find a on line or other instruction manual for this Digital Read out?
Reply

    

m.s.bisht: we wants setting least count 5 micron instead of 10 micron. please send me detail
Reply

  

Dennis Van Niel: I need to find or have ours repaired. It is a 10 " scale for a hardinge lathe model 200T. The scale number is 550505-10
Reply

  

Tom Kish: My read out keeps giving me an e3 code . The readout starts reading out then goes to e3.The scale is clean also the readerhead had everything apart cleaned with alcohol . Can you help? The mode is a Millmate 2 axis it is on a Brigeport mill. Tom
Reply

  

Eric Allen: Hello, I have a Accu-rite III dro, and just in stalled a new Y-axis scale.How do you change the resolution on the DRO?
Reply

  

Carl Vandewinckel: I have two Teledyne DRO Model 2000.Do you of anyone that can fix them? We can discuss the issue on the phone.
Reply

Craig Lindberg: To whom it may concern,I have an Accu Rite II Digital Readout System on my Bridgeport.The (X) axis reading head, is in need of a rebuild. Is this something your company does or can you refer me to someone?Any info. on this would be greatly appreciated. Thanks for your time,Craig
Reply

---