We have a 1998 Holzma HPP 1132 panel saw. We have been told that the positioning module is bad(CPNC8-23). We replace the drive motor and still intermittency.Cannot find a positioning module anywhere. CAn you repair this or locate aa positioning module for this saw? Please call me at 859-497-0058 EXT: 214Doug GessfordorDaryl EasonorDusty
If you need your Holzma unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110
We have a Holzma hpp350 panel saw and we believe the cylinder that raises the main saw is going bad. We are wondering if these cylinders can be rebuilt or if they need to be replaced, please advise and thank you
Replace green battery in comunication board.
Machine not finishing \"initialization\".It has the old small screen \"operator panel\" BRRTGR31-OF.Sequence of events:1- machine main breaker is turned to ON.2- +- fourteen seconds later, there is a glitch to the LEDs switches.3- the \"HOLZMA\" logo is displayed on the small screen.4- operator stays waiting for the 2nd glitch on the LEDs and the black boxes on the screen indicating the initialization is finished. Number 4 above never happen.There are no errors on the panel. Removed all boards but PLC and Screen I/F MC02 = same result. Any suggestions?
where can I get technical help and manuals for this saw
#Holzma by Douglas Gessford on 2020-05-20 22:07