I have one machine vertical mill Avon with crusader II anilam opertating panel.it is not in working position before to run it I want to check it servo drive cards with servo motors , I am 30 years experienced man of working in electronics and industerial equipments.these card are in very good condition, and I am sure they are in working condition. Note:-we have 3 other CNC mill to check up.card detail Westamp INCASSY 30059-some major parts detailout put bridge devices are 29794 TO3 casing mounted on heat sink/base plateIC TL082CP 8 PinIC LM 393 X 2IC LM 1458NIC MM74C08IC UA714Transister2N3019 X 22N2222A2N4856A X2and so onMotor detailServo drive Type MT 30F4-45volts 140rpm 3100cont stall tourque 1.5 NMwith tacho 9.5 volts/1000 RPM insul class FWhat I needBefore sending it for repair I want to make sure that these really need repairing,for that I need its scematic diagram to check it and run it out from the machineif that is not possible atleast its wiring diagram to hook up it with the servomotor and techo generator and give it command signal to run the motor.
If you need your Westamp - UltraDrive unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110
#Westamp - UltraDrive by Matt Saponara on 2008-06-13 13:59