WASHER IS NOTY WORKING,FUSE F21 WAS BAD,WHEN WE CHANGE THE FUSE ITS BLOW OUT AGAIN,DURING THE WASH CYCLE.
If you need your Unimac unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110
WASHER IS NOTY WORKING,FUSE F21 WAS BAD,WHEN WE CHANGE THE FUSE ITS BLOW OUT AGAIN,DURING THE WASH CYCLE.
WE NEED A REASONABLY PRICED GOOD USED OR NEW CYLINDER AND TRUNNION ASSEMBLY FOR UNIMAC DRYER MODEL # DTB75CGK ALSO CAN USE INNER AND OUTER TRUNNION BEARINGS FOR SAME MECHINE.
50lb unimac invatar control system.
Where is the nearest service shop located. Need to know the cost for maintenance and repair.
I\'m looking for a wash motor for UW60P30, slightly used or new, please e-mail me on a price. Thank you.
Gents, I need P/N for belt for UNIMAC Dryer UB075 E (big one)Thanks
I NEED KEY FOR UNIMAC WASHER KEY #3800
I removed my unimac washer drum for replacement of the bearings in the trunnion.There are two V-rings installed. The outside diameter (OD) is 8.5 inches, and the inside diameter (ID) is 5 inches and thickness is 0.5 inch. I am unable to get the part numbers or suppliers for these items.Could anyone help to identify the parts and also where I can get them.Thank you.Nizuyir Buyong.
i have a uni mac washer need to repair,not dran porporly
#Unimac by charles onstead on 2016-02-25 16:30