Sanyo Service & Repair Forum

Hello! I have a TV that when you hit the power button you hear it power off right away. I am looking for a ball park estimate on what it would cost to repair the board if I sent it to you. Thank you for your time.

— Posted by Scott Anctil on 2008-04-22

Reply🗨️Ask a New Question Below❓

If you need your Sanyo unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent Comments


#Sanyo Denki by santosh kumar chauhan on 2007-01-09 12:03
Dear sir I am using PM driver (sanyo denki PMM-MD-23120-10) for stepper motor (sanyo denki 103H71121-0410). As I selected pulse/direction mode the motor runs in CW direction only when I down the direction pin low. The output of PC4 is high when its input is low. what is wrong with PM driver ?rgdsSantosh K. ChauahnRRCAT Indore(INDIA)-452013

#Sanyo by Scott Anctil on 2008-04-22 21:07
Hello! I have a TV that when you hit the power button you hear it power off right away. I am looking for a ball park estimate on what it would cost to repair the board if I sent it to you. Thank you for your time.

#Sanyo Denki by sreekanth reddy on 2008-08-26 07:49
Sir,i am using sanmotion TS1-AA2AA for sanmotion servo motor.this a fully programmable drive.the main problem i am facing with this one is iam enabling the servo on function any time.but the servois not switched means 140v to the drive is not going.please tell me the solution,regardsSreekanth reddy.C

#Sanyo Denki by sankar on 2009-04-24 13:09
sir,our cnc m/c brother tcs2a table axis servomotor (sanyo denki) having position shifting error is facing because of encode got detororated due to coolant entry. is it possibe to change the encoder , if it is possible please guide me.thanks&regardss.sankar

#Sanyo Denki by Nir Ben-Hur on 2009-05-31 08:37
Hi,I have few (around 5) PM Driver (Model: PMAPA1A6B20) units that failed while used at TEL Prober Machine. The part age is 3-4 years.Usually the problem reflects as noisy motor and motion followed by encoder errors. What will the common repair cost for that?Best regardsNir Ben-hur972-54-3339535

#Sanyo Denki by Arpit Bhatnagar on 2010-08-28 07:14
We have one equipment in which sanmotion motor is used for motion and now gone bad. we want to repair this motor. Symptoms:- Armature jam, Tight in motion.Model no:- Q1AA06040DXS24MMake:-Sanyo Denki.Please reply soon.

#Sanyo Denki by SRIKANTH R on 2011-03-03 11:01
we have amplifier sanyo denki make1.60BA100FFW0H2.60BA030FXW0T3.60BA030FXW0PPLEASE HELP US IN GETTING CONNECTING MANUALSREPLY SOON