I have a Fortress Scooter with a P\'n\'G SOLO controller, with the wiring severely interfered with. Controller has 4 hi-current (ie, #10) wires on one end, and a pair of multi-pin connectors on the other end. One connector has 4 terminals, the other has 10. Controller is mounted in a separate case, with a loom containing Red and Black hi-current wires and a ~18 Ga. green wire in it. Also two connectors, one 6-pin, and one 9-pin. My problem is where to connect these conectors and loom on the scooter system. ie, which to motor, to throttle control, from battery pack, etc. Colours from P+G unit to in side of connectors are clear and easily distinguishable. What I need is a wiring diagram, or pin-out from the SOLO to the outside world of the scooter itself. Any help appreciated.ps
If you need your Penny And Giles unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110