Heimann Service & Repair Forum

We need the following:1. Check/validate if our unit is still Calibrated, it was not calibrated for the past 5 years.2. Do you supply a brass calibration block? what we use is steel calibration block. Our operating cylinder hardness ranges from 180 to 220 vickers, which calibration block is needed for our unit?3. Do have a local contact here in the Philippines?4. Send us quotation regarding calibration of our unit and the test block.We ddo expect for your prompt reply.Thanks,Leo TormesEngineering & Facilities Manager.

— Posted by Aurelio B. Tormes on 2006-03-20

Reply🗨️Ask a New Question Below❓

If you need your Heimann unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent Comments


#Heimann by Aurelio B. Tormes on 2006-03-20 03:30
We need the following:1. Check/validate if our unit is still Calibrated, it was not calibrated for the past 5 years.2. Do you supply a brass calibration block? what we use is steel calibration block. Our operating cylinder hardness ranges from 180 to 220 vickers, which calibration block is needed for our unit?3. Do have a local contact here in the Philippines?4. Send us quotation regarding calibration of our unit and the test block.We ddo expect for your prompt reply.Thanks,Leo TormesEngineering & Facilities Manager.

#Heimann by R.M.SHARMA on 2007-12-13 17:54
Microdur harness tester we have sent for repairing to Heimann but it is nor repairable do, help us.

#Heimann by Dorothy Wu on 2011-08-06 03:55
We need your repair service support.1) Pls provide us your mailing address and contacts in order to send our unit to you for repair service.2) Send us quotation after inspection of the unit.Your prompt reply is highly appreciated.Thanks,Dorothy Wu