We have a machine that uses glentek servo amplifier ( GA4569EPA control card and power output card ) but we are having some problem because the motor is not functioning steadily and at some times its not giving an accurate feed to the motor resulting to dimensional error on our products. What would be your sugestion regarding this matter?Regards
If you need your Glentek unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110
DEAR SIR,I HAVE A SET OF THE ABOVE EQUIPMENT WHICH A LOCAL VENDOR CLAIMED THAT THE ABOVE SET IS NON REPAIRABLE DUE TO PARTS BEING OBSOLETE AND NOT SUPPORTED NOW. PLEASE ADVISE THE SOONEST POSSIBLE WHAT IS THE PARTS SUPPORT OF THE ABOVE ITEM.THANK YOU.REGARDSCHEAH CS
Looking for a GA4555p-1 A manuel or just the inputs/outputs to the unit.
I have an Anlam Series 1 CNC with 2 Glentek GA380-8 drivesIt is wired for a 3rd axis, which I wish to add. Where can I get a Plug compatable Drive ?What are the Specifications for the Glentek GA380-8 ?
We have a machine that uses glentek servo amplifier ( GA4569EPA control card and power output card ) but we are having some problem because the motor is not functioning steadily and at some times its not giving an accurate feed to the motor resulting to dimensional error on our products. What would be your sugestion regarding this matter?Regards
Hi Sir,We are looking for repair or replacement unit for above driver board with p/n : GA 4567EPC-3A-1.Hope to hear from your soon.Thanks,kplim
#Glentek by miguel on 2009-05-18 16:43