Ferrocontrol Service & Repair Forum

We have an Elumatec MGS245 saw with an E550 controller. The controller uses a Kontron MOPSlcd6 PC/104 processor and a Ferrocontrol fieldbus card (all of these are German companies). I think that the fieldbus card is out. I think that the part number for the card is 91027100, but I\'m not sure.We need either a replacement card or to have the existing card and/or controller repaired. I have pictures of the card and controller that I can email.

— Posted by Ed Puckett on 2009-03-04

Reply🗨️Ask a New Question Below❓

If you need your Ferrocontrol unit tested or repaired,
give us a call at 1-336-969-0110.
We offer fair estimates and extended warranties on the work performed.
Shipping/Receiving:
Industrial Electronic Repair
145 Rockwell Place Ct
Tobaccoville, NC 27050
Phone: 1-336-969-0110

Recent Comments


#Ferrocontrol by John H Smith on 2007-12-07 15:47
I need cables (encoder and motor) to connect a DARC S12(35-060800) to a AC servomotor(HD142e6-130, 35161701).The cable part number are:70-25060070-251500

#Ferrocontrol by Ed Puckett on 2009-03-04 16:08
We have an Elumatec MGS245 saw with an E550 controller. The controller uses a Kontron MOPSlcd6 PC/104 processor and a Ferrocontrol fieldbus card (all of these are German companies). I think that the fieldbus card is out. I think that the part number for the card is 91027100, but I\'m not sure.We need either a replacement card or to have the existing card and/or controller repaired. I have pictures of the card and controller that I can email.

#Ferrocontrol by An, Yuping on 2009-07-27 16:04
Type: s02-00-2e, current controll error

#Ferrocontrol by Brian Borst on 2010-01-05 13:45
We have an Elumatec MGS244 saw with an E550 controller. The controller uses a PC/104 processor and a Ferrocontrol fieldbus card (all of these are German companies). I think that the fieldbus card is out. I think that the part number for the card is 91027100, but I\'m not sure.We need either a replacement card or to have the existing card and/or controller repaired.

#Ferrocontrol by Eric Haffner on 2012-07-19 02:59
We have an Elumatec SBZ122, and the monitor has gone dark.I would like to repair the display instead of replacing it (cost).Monday evening I installed a new display panel, and it worked on Tuesday, but not on Wednesday. I suspect the power supply, however the power supply is controlled by another module.I can find no evidence of any component failure.I feel the components are relatively easy to replace.I would be willing to send pictures, if you supply an email address.The machine is running, as I have connected an external monitor.Thank you,Eric HaffnerPlease CC emails to my personal address, because many time I am unable to get to a computer at work.ehaffner@trulite.com / eric.thered@yahoo.com